Fridge Freezer Hinge - (Lower Right / Upper Left)

£26.95
SKU
2211201054
Genuine Part
Typically with you in 1 to 6 days
Commonly used on these brands
Genuine Spare Part

Replacement fridge freezer hinge for the lower right and upper left door positions – compatible with AEG, Electrolux, Küppersbusch and Smeg appliances as shown unless advised otherwise

Check your fridge freezer model number to ensure a guaranteed fit.

 

Description

Getting a built-in appliance door to hang true again depends on fitting the right hinge in the right position, and this genuine spare is the factory part for the lower-right and upper-left stations. It matches the hinge originally supplied with the appliance, so the mounting plate, pivot angle, and load rating match the door it was designed to carry—no drilling, no adaptation, no compromise on the door line.

These appliances use two hinges, one at each door station, and the two are handed differently. This listing covers the lower right and upper left hinge; the opposite station is supplied as a separate part. Because the furniture door hangs from the same fixing points, replacing a worn hinge with the correct handed part restores an even gap along the top, bottom, and hinge edge.

This part will only fit the models as shown or as specifically advised and will not fit any others. Please check your model number carefully against the compatibility list before ordering.

Important

Replace these hinges as a pair, not individually; if one has failed, the other will likely be worn and may have failed, though perhaps not obviously. Replacing only one can strain the new hinge, causing premature wear and failure.

Technical Notes

Specifications: Fridge freezer door hinge, opposite hand. Fits the lower-right and upper-left door positions. Product code: 2211201054. Supplied as a single hinge unit. Steel hinge mechanism with moulded mounting components. Direct replacement for the original factory-fitted hinge. Note: two hinges are used per appliance, and the opposite station is supplied separately.

Safety note: The hinge holds a loaded door under tension, so support the door on a prop or with a second pair of hands before releasing any fixings. Isolate the appliance from the mains first, and handle the furniture door carefully while it is detached.

 

AEG FRIDGE FREEZER

ABE810F6NF (922761012), AIK2853L (925512032), AIK2853R (925512031), S18E5T (925516108), SCB618F3LF (925512025), SCE618F3LF (925512028), SCE81826TC (925516125), SCE818E6TF (925516102), SKB810E1AF (923761024), SKE810E1AF (923761023), SKK810EDAF (923761025)

 

ELECTROLUX FRIDGE FREEZER

ENT7TE18R (925516114), LNT7TE18R (925516101)

 

KUPPERSBUSCH FRIDGE FREEZER

FK3800.1I (923761026), FKG8500.2I (925516107)

 

SMEG FRIDGE FREEZER

C8174DN2E (925516106)

Get Expert Fridge Freezer Spare Part Help

Can't find your model number listed or need help identifying the correct part? Contact our parts advisors with your full model and serial number, and we'll verify the correct part for your appliance.

More Information
Further Description

Common Faults & Symptoms

The symptoms below are the ones most often reported when a hinge at the lower right or upper left station has worn out. Treat this as a diagnostic guide — if several are present together, the hinge is the likely cause.

1
Uneven Gap Down the Hinge Edge
A widening or tapering gap between the door and the carcass along the hinge side is one of the earliest signs. The door is no longer being held square by the hinge at that station.
2
Door Corner Dropping at the Bottom
If the bottom corner on the hinge side hangs low, the lower right hinge has lost its grip on the door. The weight of the door gradually works a worn hinge further out of position.
3
Door Twisting as It Opens
When the two hinges are no longer working in step, the door twists slightly on its axis. This is felt as a judder or a slight twist in the hand as the door swings open.
4
Furniture Door Rubbing on the Plinth
On integrated models a sagging hinge shows up first on the cabinet front rather than the appliance door. If the furniture door scuffs the plinth or a neighbouring unit, check the hinge before adjusting the brackets.
5
Door Springs Back or Will Not Stay Open
A hinge that has lost its internal friction lets the door fall closed on its own, or refuses to hold at the open position. This makes loading and unloading awkward and points to a worn hinge mechanism.
6
Cold Air Leaking Along One Edge
A door pulled out of line at the hinge side compresses the gasket unevenly. One edge seals, the other does not, and the appliance runs longer to hold temperature.
7
Clunk or Snap at the End of Travel
A sharp noise as the door reaches fully open often comes from a partially fractured hinge arm or a pivot that has worn oval. Continued use in this state can crack the hinge completely.
8
Hinge Mounting Plate Lifting Away
With the door open, look at where the hinge meets the cabinet. A mounting plate that stands off the surface or a fixing hole that has opened up means the hinge can no longer be trusted to carry the door.

Fitment Guidance

This part is compatible only with the models listed in the compatibility matrix above. Handed hinges look similar at a glance, so position matters as much as model number.

  • This hinge serves the lower right and upper left door positions; the opposite station uses a different part.
  • Check your full model and PNC number against the AEG, Electrolux, Küppersbusch and Smeg lists before ordering.
  • If both hinges are worn, order one of each listing rather than two of the same part.
  • If your model is not listed, contact our parts team with the model and serial number from the rating plate to confirm fitment.

Diagnostic Tips

Before concluding that the hinge has failed, carry out these checks to rule out other causes.

  • Check the fixings first: A hinge that has simply worked loose will tighten back up. If the screws bite and hold, the door line may correct itself without a new part.
  • Test one hinge at a time: Support the door and release one hinge at a time to see which station is allowing movement. This confirms which part needs replacing.
  • Inspect the gasket separately: Run a finger around the seal with the door shut. A gasket that grips evenly but still leaks points to door alignment rather than the seal itself.
  • Look at the furniture door brackets: Sliding and fixed brackets on integrated doors can loosen on their own and mimic a hinge fault, so check them before ordering.

Installation Guide

These steps describe the general procedure. The exact sequence varies between models, so always consult the appliance service manual where available.

  1. Isolate the appliance from the mains and empty the door shelves to reduce the weight being carried.
  2. Support the door on a padded prop or with a helper before loosening any hinge fixing.
  3. Disconnect the furniture door from the appliance door and note the bracket positions for refitting.
  4. Release the hinge fixings at the station being replaced and lift the old hinge away.
  5. Seat the new hinge in the same orientation, fit the screws finger-tight, then align the door before final tightening.
  6. Refit the furniture door, check the gaps on all four sides, and adjust the brackets as needed.
  7. Restore the power and confirm the door seals evenly before reloading the appliance.

Before Ordering, Check These First

  • Confirm you need the lower right and upper left hinge, not the opposite station.
  • Verify your model and PNC number against the AEG, Electrolux, Küppersbusch and Smeg lists.
  • Check whether the existing hinge screws are reusable or whether new fixings are required.
  • Rule out loose furniture door brackets and a worn gasket before ordering.
  • Verify your full model number — typically found on the rating plate inside the fridge compartment.

Disclaimer: The fault codes and symptoms listed above are intended as a general guide to assist with diagnosis. They cannot be taken as a definitive diagnosis of any particular problem, and other components may produce similar symptoms. Always confirm the fault with proper testing before ordering parts.

Alternate Part Number DST2211201054, 094.003EL, 2211201021, 931332041, SMG931332041, 4055504197 (kit), Hettich 3705 / 3363
EAN Number 7321424476633
Manufacturer Genuine Lux1AE
Genuine Part Yes

Appliance Spares 

Integrated
Door Hinges

Fridge and freezer door hinges wear over time, causing doors to rub, misalign, or even fall. Replacing worn hinges ensures safe and smooth operation.

About Integrated Door Hinges

Door hinges on integrated fridges and freezers are often Hettich or Ingol, although other brand-specific hinges exist. Top and bottom hinges are usually “opposite” of one another, swapping positions if the door is reversed.

We strongly recommend replacing both hinges at the same time. Many manufacturers now sell door hinges as a kit, as if one fails, the other is likely to follow soon after.

To identify Hettich hinges, check the number stamped on the plate fixing the outer wooden door (e.g., 3362 5.0). The hinge end may have a number (41.5 or 45). If it’s 45, contact us before ordering, as these can be model-specific.

Need Help Finding Door Hinges?

Contact us with your fridge or freezer make, model, and serial number. We’ll help you identify the correct integrated door hinges and provide any compatible alternatives if available.

Contact Support Team
AEG AEG Brand - Electrolux Group

AEG
Spare Parts.

AEG is a German brand within the Electrolux Group. Older German-made appliances were well-regarded, though more recent models vary in quality. Correct identification of spare parts is essential due to multiple variants per appliance.

Model & PNC Verification

To accurately locate AEG spare parts, you will usually need the Product or PNC number from the appliance rating plate. This ensures compatibility across multiple variants, which may range from a few to over thirty per model.

Product / PNC Number
Rating Plate Data
Cross-Brand Compatibility
 

Ordering & Assistance

Some AEG parts are straightforward to order, while others require careful verification. If unsure, please contact us to get guidance on correct parts and possible lower-cost alternatives.

 

Group Compatibility

AEG spare parts are used across multiple Electrolux Group brands. Thankfully, all products function similarly, making cross-brand identification easier.

Confirm Your AEG Spare Parts

Provide the Product or PNC number from your appliance’s rating plate and our team will confirm the correct AEG spare parts for your model quickly and accurately.

Contact Support Team

German Brand • Verified Fitment • Electrolux Group • Established 1988

NWAR SUPPORT

Spare Parts Help

Identifying technical spares can be a minefield. Our specialist help desk is available via email to cross-reference your model and identify the most cost-effective genuine or alternative options.

Avg. Response Under 60 Minutes
Service Type Expert Verification
Ask A Specialist

Or use the live chat widget below.

UK'S Professional Appliance Spare Part Network • Established 1988

Logistics & Support

Delivery & Returns Information.

We aim to get your parts to you as fast as possible. We are transparent about lead times, stock availability, and our returns process to ensure a smooth repair.

Stock Availability

Please be aware that we show availability but do not display live stock levels online. Estimates are based on average manufacturer lead times.

Tradesman Warning

Do not arrange a tradesman until your goods have arrived and been checked. We do not cover tradesman costs due to transit delays or suitability issues.

Understanding Lead Times

1 to ** Days

Normally a UK stock item. Dispatched same or next working day. Some items may take longer depending on specific warehouse location.

3 to ** Days

Usually a UK/EU stocked item but with a longer lead time. Contact us before ordering for specific clarification if the repair is urgent.

* to ** Days

Factory or Custom order items. These are ordered specifically for you and cannot ordinarily be returned. Please allow the full time indicated.

Order Transit

Orders placed before 3:00 PM (Mon-Fri) for in-stock items are typically dispatched same-day.

We use Royal Mail, DPD, and Evri. Tracking information is emailed upon dispatch. Delivery times to rural or offshore areas will vary.

Heavy/Oversized Items

Items such as dishracks, tubs, and glass cooktops may incur additional fees due to weight and specialised packaging requirements. We will contact you if additional shipping is required.

Returns Policy

Damages

Report transit damage within 24 hours. Include a photo of the damage and the packaging to speed up the claim process.

Cancellations

You have 14 days after delivery to cancel. This must be done via email or support ticket (not phone/chat).

Exclusions

We cannot accept returns for items that have been fitted for fault-finding, used, or custom-ordered.

How to Return an Item

1

Contact us with your order number and reason for return.

2

Wait for instructions and the correct returns address (this varies by item).

3

Package carefully. Do not deface original packaging. Use tracked post.

Have questions about your delivery or a potential return?

Contact Support Team

98% of orders delivered on time • Expert Resolution • Established 1988

Thousands of Parts in Stock

Ready for quick dispatch and delivery. Our advisors can also help you identify spare parts faster and save you time.

Fast Free Advice Mon-Fri, 9am - 5pm
Contact Our Parts Specialists
© NWAR. All rights reserved. Manufacturer logos, images and documentation for informational purposes only.