Oven Fan Motor
Replacement oven fan motor – compatible with Beko, Belling, Cookmaster, Flavel, Lamona and Leisure models as shown unless advised otherwise
Description
This genuine Beko oven fan motor is identical to the original fitted at the factory, restoring the steady, even heat circulation that fan-assisted cooking depends on.
The motor drives the impeller behind the rear panel of the oven cavity, moving hot air through the chamber so that temperatures stay consistent from shelf to shelf. When the motor weakens or fails, the oven either stops circulating heat altogether, leaving food undercooked and uneven, or becomes noisy and slow. Fitting a genuine replacement brings back the reliable, quiet performance the appliance was designed to deliver.
This motor is used across a very broad spread of Beko, Belling, Cookmaster, Flavel, Lamona and Leisure ovens, which is why the same component appears under so many brand names. Motors of this type look similar between models but differ in shaft dimensions, mounting brackets and electrical connectors, so the model number should be confirmed rather than judged by appearance.
This part will only fit the models as shown or as specifically advised and will not fit any others, even if it looks the same. Please take time to confirm your model number before ordering. If you are unsure please don't hesitate to contact us and ask for assistance.
Technical Notes
Specifications: Genuine Beko oven fan motor; 220–240 V AC; 50–60 Hz; 32 W; approximate weight 560 g; product code 264100010. Alternate part numbers: 264100004, C00890478. Approximate dimensions and weights are for guidance only and must not be used to identify the part.
Note: This motor is also supplied under the manufacturer reference C00890478. Please compare the old motor where it is still accessible, as mounting brackets and shaft dimensions can differ between production runs.
Safety note: This motor operates at mains voltage. Isolate the oven from the power supply at the isolator before removing panels, and allow the motor to come to a complete stop before handling it. Confirm that all electrical connections are secure and the impeller is free to rotate before restoring power. Fitting and testing should be carried out by a competent person.
⚠️ Warning: Limited availability – please check before ordering.
BEKO OVEN & COOKER
BEO 1450 X (7736588656), BEO 1680 L (7737989205), BFD 6654 MR (7714687601), BIO 1450 X (7736688655), CE 51220 SX (7700688356), CE 68200 S (7701188344), CE 68206C (7752087634), CE 88000 (7752089015), D533AK (7737086303), D533AS (7737086302), D533AW (7737086301), D533K (7737086314), D533S (7737086343), D533W (7737086313), D533X (7737086353), D653W (7739086312), D653X (7739086352), DC543X (7734586353), DC643S (7734986302), DC643W (7734986331), DV555AS (7734486302), DV555AW (7734486301), DV555AX (7734486303), DV555S (7734486343), DV555W (7734486313), DV555X (7734486353), DV655S (7739086343), DV655W (7739086313), DV655X (7739086353), DVC563AK (7722886303), DVC563AW (7722886302), DVC563S (7722886344), DVC563W (7722886314), DVC565X (7734686353), DVC663K (7737186333), DVC663S (7734986349), DVC663W (7734986329), DVC665S (7737186343), DVC665W (7737186314), DVC665X (7737186353), SAMP CM 58202 X (7717886701), SC524X (7751086353)
BELLING OVEN & COOKER
317AN (6606363804), 317SI (6606363805), 317WH (6606363802), 356WH (6606863013)
COOKMASTER OVEN & COOKER
CM101FRCP (7726586384), CM101FRKP (7726586334), CM105FRNP (7726586308), CM105FRRP (7726586306), CMT100FRCP (7726586301), CMT100FRKP (7726586302), CMT102FRKP (7726586305), CMT105FRRP (7726586307)
FLAVEL OVEN & COOKER
AP10FRKP-1 (7719986337), AP10FRSP (7719986338), FN10FRSP (7719986358), ML10CRS (7726986301), ML10FRSP (7719986357)
LAMONA OVEN & COOKER
LAM5100 (7757586392)
LEISURE OVEN & COOKER
CM09C (7757587638), CM09X (7757587630), CM101CRR (7726586312), CM105FRBP (7726586313), CM105FRWP (7726586309), CM10 FRKP (7726587311), CMCE93K (7757486355), CMCE96K (7757486353), CMCE96S (7757486352), CMCE96X (7757586382), CMCF93K (7757586390), CMCF96K (7757586387), CMCF96S (7757586384), CMCF96X (7757586383), CMCF99B (7757586312), CMCF99C (7757586314), CMCF99K (7757586315), CMCF99RP (7757586305), CMCF99W (7757586313), CMCF99X (7757586316), CMT102FRCP (7726786307), CMT105FRWP (7726586311), CMTE94C (7757586386), CMTE94K (7757586381), CMTE95C (7757586380), CMTE95K (7757486354), CMTF95C (7757586389), CMTF95K (7757586331), CMTF99B (7757586340), CMTF99K (7757586310), CMTF99N (7757586306), CMTF99R (7757586311), CMTF99W (7757586307), DC10CRX (7726986302), DC10FRXP (7726786308), HAP5000 (7757586320), HAP5001 (7757586321), HJA5093 (7757586360), HJA5110 (7757586388), LFS6MX (7736186355), LFS6RPX (7737986356), LFS6RX (7737986355), RCM10CRK (7726986334), RCM10CRS (7726986343), RCM10CRX (7726986336), RCM10FRKP (7726786335), RCM10FRSP (7726786345), RCM10FRXP (7726786336), RCMT102FRKP (7726786337), RCMT102FRXP (7726786306)
Get Expert Oven & Cooker Spare Part Help
Can't find your model number listed or need help identifying the correct part? Contact our parts advisors with your full model and serial number, and we'll verify the correct part for your appliance.
| Further Description |
Common Faults & SymptomsThe following symptoms are commonly reported when a Beko oven fan motor begins to fail. Use this as a diagnostic guide before ordering a replacement — if more than one of these is present, the motor is the likely culprit. 1
Oven heats unevenly or cooks too slowly
The most common sign. Food browns on one side but stays pale on the other, or cooking times stretch far beyond normal because the fan is no longer circulating heat evenly through the cavity.
2
Fan not running at all
The oven heats up but the fan behind the rear panel does not turn. This is a clear sign that the motor has seized or its windings have failed, and fan-assisted modes will not work correctly.
3
Grinding, squealing or rattling noise
A metallic grinding or high-pitched squeal from the rear of the oven points to worn bearings. A rattling sound may indicate a loose impeller or debris caught in the fan housing.
4
Oven overheats or trips the safety thermostat
If the motor is failing, heat can build up unevenly, causing the oven to overheat or the safety thermostat to trip mid-cycle. The oven may cut out and refuse to restart until it has cooled.
5
Fan runs intermittently
The motor starts and stops unpredictably, or only runs after the oven has been on for some time. This can indicate a failing motor or a loose connection at the terminal block.
6
Burning smell from the rear of the oven
A sharp electrical burning smell near the fan motor indicates overheating windings or a failing capacitor. Stop using the oven and isolate the power until the fault has been investigated.
7
Oven trips the circuit breaker
If the kitchen circuit trips when the oven is switched on, the motor may have shorted to earth. Isolate the supply and do not re-energise the appliance until the fault has been tested.
8
Visible damage to the impeller or motor housing
Cracked or melted plastic around the motor, or a damaged impeller, points to overheating or physical obstruction. In either case, the motor assembly should be replaced rather than repaired.
Fitment GuidanceThis motor is compatible only with the Beko, Belling, Cookmaster, Flavel, Lamona and Leisure models listed in the compatibility matrix above. Even if a motor looks visually similar, the shaft dimensions, mounting brackets and electrical connector can differ between oven ranges.
Diagnostic TipsBefore concluding that the motor needs replacing, carry out these checks to rule out other causes.
Installation GuideThese steps describe the general procedure. The exact sequence varies between models, so always consult the appliance service manual where available.
Before Ordering, Check These First
Disclaimer: The fault codes and symptoms listed above are intended as a general guide to assist with diagnosis. They cannot be taken as a definitive diagnosis of any particular problem, and other components may produce similar symptoms. Always confirm the fault with proper testing before ordering parts. |
|---|---|
| Alternate Part Number | FVL264100010, BEKBE264100010, C00890478, 264100004 |
| EAN Number | 264100010 |
| Manufacturer | BEK |
| Genuine Part | Yes |
Oven
Fan Motors
Oven fan motors blow air across the heating element to ensure even temperature and consistent cooking. Faulty motors can overheat, drag, or run noisily, affecting cooking performance and element longevity.
Replacing Oven Fan Motors
Oven fan motors are usually rear-mounted and circulate air over the fan oven element. Grease or cooking debris can cause drag, hotspots, or premature element failure. Always check that blades spin freely before replacement.
Even slight differences in blade size, fixings, or mounting can affect fit. Ensure you have the correct model number or product code before ordering a replacement motor.
Can't Find The Oven Fan Motor You Need?
Oven fan motors vary slightly between ranges. If you’re unsure of the correct replacement, provide your oven or cooker model and we’ll help you find the correct motor, including low-cost compatible options.
Contact Support TeamBeko
Spare Parts.
Beko produces appliances across multiple variants, and identification of the correct spare parts often requires the model number and, in some cases, the product code or serial number. Many parts are shared across brands owned or produced by Beko, including Hotpoint, Whirlpool, Blomberg, Grundig, and Flavel.
Correct Model Identification Is Essential
To find the correct Beko spare parts, you will need at least the model number. Some appliances also require the product code or serial number for precise identification. The rating plate contains this key information, including the manufacturing date.
Variant & Modification Awareness
Some Beko spare parts have been modified over time, so the replacement part may differ visually from the original. Careful identification using the model, product code, and serial number is essential to ensure the correct fit.
Confirm Your Beko Spare Parts
Provide the model number, product code, and/or serial number or a photo of the rating plate from your appliance, and our technical team will confirm the correct Beko spare parts for your appliance quickly and accurately.
Contact Support TeamTurkish Manufacturer • Multi-Brand Parts • Verified Fitment • Established 1988
UK'S Professional Appliance Spare Part Network • Established 1988
Delivery & Returns Information.
We aim to get your parts to you as fast as possible. We are transparent about lead times, stock availability, and our returns process to ensure a smooth repair.
Stock Availability
Please be aware that we show availability but do not display live stock levels online. Estimates are based on average manufacturer lead times.
Tradesman Warning
Do not arrange a tradesman until your goods have arrived and been checked. We do not cover tradesman costs due to transit delays or suitability issues.
Understanding Lead Times
Normally a UK stock item. Dispatched same or next working day. Some items may take longer depending on specific warehouse location.
Usually a UK/EU stocked item but with a longer lead time. Contact us before ordering for specific clarification if the repair is urgent.
Factory or Custom order items. These are ordered specifically for you and cannot ordinarily be returned. Please allow the full time indicated.
Order Transit
Orders placed before 3:00 PM (Mon-Fri) for in-stock items are typically dispatched same-day.
We use Royal Mail, DPD, and Evri. Tracking information is emailed upon dispatch. Delivery times to rural or offshore areas will vary.
Heavy/Oversized Items
Items such as dishracks, tubs, and glass cooktops may incur additional fees due to weight and specialised packaging requirements. We will contact you if additional shipping is required.
Returns Policy
Damages
Report transit damage within 24 hours. Include a photo of the damage and the packaging to speed up the claim process.
Cancellations
You have 14 days after delivery to cancel. This must be done via email or support ticket (not phone/chat).
Exclusions
We cannot accept returns for items that have been fitted for fault-finding, used, or custom-ordered.
How to Return an Item
Contact us with your order number and reason for return.
Wait for instructions and the correct returns address (this varies by item).
Package carefully. Do not deface original packaging. Use tracked post.
Have questions about your delivery or a potential return?
Contact Support Team98% of orders delivered on time • Expert Resolution • Established 1988